![may in canon lbp 2900 gia bao nhieu may in canon lbp 2900 gia bao nhieu](https://suamayinhaiduong.com/uploads/z2299775105447_d570f53e7a2b6d472b62b8501ce72f94.jpg)
MAY IN CANON LBP 2900 GIA BAO NHIEU REGISTRATION
(The BICU generates the FGATE signal and sends it to the LD unit when the registration sensor switches on.) The FGATE signal does not assert within the prescribed time. The laser synchronizing detection signal for the start position of the LDB is not output for two seconds after LDB unit turns on while the polygon motor is rotating normally. Laser synchronizing detection error: start position LD1
![may in canon lbp 2900 gia bao nhieu may in canon lbp 2900 gia bao nhieu](https://muagitot.com/images/news/2020/12/17/large/avatar-may-in-canon-lbp-2900-gia-re_1608171134.jpg)
The polygon mirror motor does not leave the READY status within 3 sec. The polygon mirror motor does not reach the targeted operating speed within 10 sec. Incorrect installation of the copy data security board.The copy data security board is not detected when the copy data security function is set "ON" with the initial setting.Ī device check error occurs when the copy data security function is set to "ON" with the initial setting. Defective connection between IPU and SBU.The error result of self-diagnostic by the ASIC on the IPU is detected. Incorrect position or width of white plate scanning (SP4015).Defective detection circuit on the BICU ĭuring the SBU adjustment, the machine detects that the white level read from the white plate or paper is out of range.The SBU connection cannot be detected at power on or recovery from the energy save mode. White plate mounting is incorrect or defective.Lamp stabilizer connection loose, disconnected or damaged.
![may in canon lbp 2900 gia bao nhieu may in canon lbp 2900 gia bao nhieu](https://anphat.com.vn/media/product/3977_10000804_m__y_in_canon_laser_lbp_2900_04.png)
Automatic white density adjustment failed when reading standard white plate.When the machine was powered on, automatic adjustment of the SBU failed.Dirty exposure glass or optics section.The white level cannot be adjusted within the target during auto gain control.
![may in canon lbp 2900 gia bao nhieu may in canon lbp 2900 gia bao nhieu](https://sivitech.vn/wp-content/uploads/2020/06/canon-lbp-2900.jpg)
The black level cannot be adjusted within the target value during the zero clamp. Harness between SIB and scanner HP sensor disconnected.SIB or scanner motor drive board defective.The scanner home position sensor does not detect the “ON” condition during initialization or copying. Scanner wire, timing belt, pulley, or carriage defective.Harness between SIB and HP sensor disconnected.Harness between SIB and scanner drive motor power source disconnected.Harness between SIB and scanner drive motor disconnected.The scanner home position sensor does not detect the “OFF” condition during initialization or copying. Scanner mirror or scanner lens out of position or dirty.The standard white level was not detected properly when scanning the white plate.
MAY IN CANON LBP 2900 GIA BAO NHIEU CODE
Công ty CP Thiết Bị Văn Phòng AT Việt Nam CODE